• Norway - English [ change ]

    E-mailEmail

    close

    We're pleased that you want to share this information. To send a link to this page, fill in the information below. The e-mail will show you as the sender and will show your return address.

    * indicates required information

    * Recipient E-mail:

    Each address entered must be valid.
    (Separate multiple email addresses with commas. Limited to 5 addresses.)

    * Your Name Here:

    Enter your name.

    * Your E-mail:

    Enter a valid address.

    send a copy to me
    Note: You are not adding recipient email addresses to any promotional email list.

    Sending...
    Sent!
    Send failed. Please try again later.

    Extrusion Coating

    Extrusion Coating banner

    Compounding

    Our Leistritz compounder can combine thermoplastic resins at the percentages you specify to create a custom blend of your materials. Liquid and powder additives can be introduced into the process to optimize your material properties.

    The end result is a customized material in pellet form that is ready to be used in one of our extrusion coating processes.
     

    Small Scale Extrusion Coating

    Our small-scale extrusion coater allows you to cast sheets from 10 to 1,000 microns thick or coat layers of 1 to 500 microns thick onto paper or plastic webs. Sample widths are 6" or less, and a minimum of 20 lbs of materials is required. Final sample format can be either wound rolls or chopped sheets.

    A range of equipment options allows us the ability to configure this process to meet almost any product need.
     

    Intermediate Scale Extrusion Coating

    Our intermediate-scale extrusion coater allows you to cast sheets from 10 to 1,000 microns thick or coat layers from 1 to 500 microns thick onto paper or plastic webs. Samples can be up to 16" wide, and typically 60 lbs of materials is required. Final sample format is wound rolls, but off-line slitting and chopping is available if needed.